BALL VALVES / Brass Ball Valves: |
|
Screwed body cap, PTFE seats, Blowout-proof stem.
Screwed ends to BS 21. Nickel plated body.
Chrome plated ball. |
 |
| BUTTERFLY VALVES: |
 |
BALL CHECK VALVE, BCV |
Ball Check Valves |
1. Silent closing, no water hammer.
2. Good Sealing.
3. Full bore flow, large flow.
4. Small resistance.
5. Loss or water head is 50% lower than swing check valves.
6. Installation: horizontal or vertical |
|
| Brass Spring |
 |
| Cast Iron Check Valves |
|
1. Design and Manufacture conforms to BS5153
2. Flange dimensions conforms to BS4504 PN16
3. Face to Face dimensions conforms to BS5153 PN16
4. Testing conforms to BS6755
5. If special request, the valve can be with external Lever and Counter Weight (L.W.) |
 |
| Double Disc Wafer Swing Check Valves |
 |
Brass Gate Valves |
|
| Cast Iron Gate Valves - INDUSTRIAL PATTERN GATE VALVE with brass resp. bronze trim. |
Inside Screw, Non-Rising Stem, Bolted Bonnet, Solid Wedge Disc
1. Can be changed with indicator on gland
2. Face-to-face dimensions conform to BS 3464
3. The dimmensions and drilling of end flanges conform to BS 10 table E or D
|
|
Outside Screw & Yoke, Rising Stem, Bolted Bonnet, Solid Wedge Disc
1. Face-to-face dimensions conform to BS 3464
2. The dimmensions and drilling of end flanges conform to BS 10 table E or D
3. Yokes are integral with bonnets, sizes 3-inch and smaller. |
|
Knife Gate Valves |
Knife Gate Valves / PN10/16 Bi-Directional
1. Design as DIN3352, MSS-SP-81
2. F TO F: DIN3202, MSS-SP-81
3. Testing: DIN3312
4. Working temperature: NBR ? 80°C, EPDM ? 120°C |
|
Knife Gate Valves / PN10 with Pneumatic Actuator, Uni-Directional
1. Testing DIN3230
2. Working temperature: NBR ? 80°C, EPDM ? 120°C |
|
PN10 Rising Spindle Handweel Operated,, Uni-Directional
1. Face to Face Non Standard
2. Testing DIN3230
3. Working temperature: NBR ? 80°C, EPDM ? 120°C
|
|
| |
|
|
|
 |
CAST IRON FIRE HYDRANT VALVE,
Epoxy Powder Coated
|
HYDRAULIC TEST PRESSURE
Body - 2000 kpa
Seat - 2000 kpa |
|
|
DIN CAST IRON STRAINER
1. Face to Face dimensions according to DIN3202, F1
2. Flange dimensions according to DIN2501 PN 10/PN16
3. Nominal Pressure PN10/PN16
4. The mesh of wire screen or the hole dimensions of the perforated screen can be as per the customer's requirements. |
|
|
|
|
